The photo shows the pc20 throttle half open. The top and bottom are reversed.
I use standard chalk for PC20. To put it simply, there is no need to change the setting unless you feel uncomfortable. If there is no dandruff, pull the chalk and open the accelerator with the same opening. Then, if the condition goes up, it is now thin, so it will be thicker (enlarge the jet diameter). When the condition gets worse, make it thinner (smaller the jet diameter). It’s easy. If you pull (close) the chalk, the air pass will be blocked like this. Pulling about half can affect the fuel tone, so let’s pull it while adjusting it. When you get used to it, you feel like you can understand how crazy you are in the pulling. maybe. I set it first from the main. Because the influence is great. If you can run without stalling with idol adjustment, check if it will blow up comfortably when the accelerator is fully opened. If you absolutely stall with idling, you may want to check 바카라 the 2 slow system at the same time. You will need to replace the main jet. Prepare the necessary parts that you can trust and work while recording the data (if you do not know the meaning of trust, please see the previous section). Choosing parts is not good. Do you think that all different after -paste makers are producing them in exactly the same standard as other companies for the convenience of users? If you are in good shape, go next. If it is no good, it is a chalk. This is because it is not a part that can be adjusted with a screw. Let’s work while recording the data (if you do not know the meaning of trust). Choosing parts is not good. I wrote in detail here that the jet shape would be different if the after -part manufacturers were different. The photo is the main jet in the middle part. Keihin Komaru type. I was writing.
2, Air Screw, Srojet
Once the main is decided, the next time we will give a sense of idling stability. If the idol is not stable, the sense of security in waiting for a traffic light will be impaired. A signal waiting stall is quite embarrassing as an example of a setting failure, so I want to avoid it as much as possible.
Small gold -screws are air screws, silver -screws are idol adjustment screws. Once you can keep rotating with idol adjustment, look for the place where the engine speed is the highest in the air screw. Please understand.
It is said that the standard is open 1 and 1/2 from the entire tightening, but I wonder if you don’t care too much. It is OK if the setting comes out in the 0-3 rotation, but if it is too far away (0.5 or less, 2.5 or more, etc.), there is plenty of time, including the meaning of seasonal changes and management to various margins. I think it’s good to replace the sloget to give it. Even if you use a chalk around here, you can understand it, so please think about it.
3, Jet Needle
If you start to open the accelerator from the rotation speed close to idling, you need to adjust. If you get rid of the moment you open it, open the accelerator and pull it at the same time. So if the dandruff rises smoothly, lower the clip stage of the needle (raise the needle). If the opposite, raise the step (lowering the needle).
Then, if you do it here, just check whether it will rotate to the opening throughout. In most cases, it should end in one lap. If there is a bad part, go around each time.
The reason for matching the main jet, but even if you change one somewhere, it will have a lot of effects in the whole area. So he wants to set the most influential main.
As long as the main set is out, there is less danger because it will run normally if you make it fully open. Riding a car with acceleration in case of emergency is not only safe but comfortable. And to set the main jet, you have to open the cab, so it’s troublesome to do it later. That’s why.
If the main comes out, the rest will be quicker, so the work later is that it will be managed by air screw and needle. I feel nice in mental hygiene, but how about?
For the time being, a summary.
1. Do the main jet.
2. Slow system with idling.
3. Adjust the tsuki with a needle.
Then, if you remember something again, I will add it!
Today, a friend from college came, but I celebrated the wonderful dish of Baccarat.
Just the right size for salads!
There is such a wonderful dish!
Baccarat is really beautiful and you can see it all the time.
There are six good members in college. Actually, since the first time I got married, everyone has been sending Baccarat glasses ♪
I wrote it here before, but except for this companion, I had never sent anything to my friend’s wedding celebration,
Everyone is really really helping. 。
I realized the narrowness of my heart.
I usually give me a surprise, but some of my friends asked me, “What are you good?”
Even if you say “Present is good ~”
“If you don’t make a request, will you 더존카지노 buy it without permission?”
And,
“How about Kuchipole’s coloraties?”
“How about the Balmuda toaster?”
I will propose something that costs more than 20,000 yen, so I will request. 。
Thinking about thinking. Click here for requested
↓ ↓
Kettle is a necessity because my husband puts coffee every morning ♪
In the future, if I have a chance to send something to someone’s wedding celebration, I think these two are very good because of their practicality ♪.
by the way,
Click here for Kuchipole’s coloraties ↓
This is also wonderful as a gift.
Click here for Balmuda toaster ↓
As expected it was expensive and I refused